Arrma Infraction Front Bull Bar Bumper DIY Installation Kit for Stock Splitter

This listing is for a DIY Arrma Infraction Front Bumper / Bash Bar / Bull Bar.

Adds a nice custom look to your Arrma Infraction.

Fits the plastic Stock Splitter or our Aluminium Splitter - Listing includes tool for perfectly marking hole positions.

Included:
1x Plastic Front Bull Bar
1x Drill Hole Guide (used for marking positions of the 2 mounting holes)
2x Stainless Steel Countersunk Screws

Fitting is very straightforward (see photo 4 for fitting instructions).
1 - Use included hole guide to mark the two hole positions
2 - Use a 3mm drill bit to drill the 2 holes
3 - Use a 6mm drill bit to countersink the underside of the two holes (to allow screws to sit flush)
4 - Screw the included screws into the bull bar from the underside of the car

Note - It's much easier to remove the splitter from your RC before installation.

This listing is for the Bull Bar DIY kit only. No splitter is included with this listing!

Supplied in Colour: Black